Arcom ZyWAN Instrukcja Obsługi Pobierz pdf (Strona 25)

Configuring the Transportal Interlock Monitor

SM-1H1.0002, Rev. 1, July 2009 4-5

NOTE

The data shown in these web page views are only representative of

the configuration data required for a specific interlocking. Each

TIM must be configured with interlocking-specific data for that

location.

Each TIM must also be configured with specific network- and

SNMP-host interface parameters for that location.

• Enable ETH0? (ETH1?) Select “Yes” and configure each port as described below:

Use DHCP? – Select 'No" for this TIM application and enter the following:

IP Address – Enter the numeric address for the TIM. Each field must be a whole

number between 1 and 255.

Subnet Mask – Enter the subnet mask for this network. Each field must be a whole

number between 1 and 255.

Default Gateway – Enter the numeric address of the default gateway (if used) for this

network. Each field must be a whole number between 1 and 255.

Preferred DNS Server – Enter the numeric address of the preferred DNS server (if

used) for this network. Each field should be a whole number between 1 and 255. If

no preferred DNS server is used, each field should be zero (0) or blank.

Alternate DNS Server – Enter the numeric address of the alternate DNS server (if

used) for this network. Each field should be a whole number between 1 and 255. If

no alternate DNS server is used, each field should be zero (0) or blank.

• Run DHCP Server: – Select “No” for this TIM application.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 51 52

Brak uwag

Arcom ZyWAN Instrukcja Obsługi Strona 25