Arcom ZyWAN Instrukcja Obsługi Pobierz pdf (Strona 28)

Configuring the Transportal Interlock Monitor

4-8 SM-1H1.0002, Rev. 1, July 2009

NOTE

The data shown in these web page views are only representative of

the configuration data required for a specific interlocking. Each

TIM must be configured with interlocking-specific data for that

location.

Each TIM must also be configured with specific network- and

SNMP-host interface parameters for that location.

• Open Ports Table – Allows viewing and configuring available inbound ports. Only

three ports (1, 2, and 3) are used in this TIM application.

Inbound Port – Enter the numeric address for each active incoming connection.

Valid port addresses range from 1 to 65535.

Protocol – Select the port protocol from the dropdown list (TCP or UDP).

• Enable Port Forwarding – Not used in this TIM application.

• Enable NAT – Select “Yes” for this TIM application and enter the following:

Source Network Address – Enter the numeric IP address for the source to be

translated. Each field should be a whole number between 1 and 255.

Source Interface – Enter the name of the network interface (typically “eth0”)

containing the source network address to be translated.

Destination Interface – Enter the name of the network interface (typically “ppp0”)

that is to receive the translation output.

• Time Synchronization – Select the desired synchronization method and time server(s).

Time Synchronization – Only the NTP method for synchronizing time is available in

this TIM application.

NTP Servers to Use – Enter the IP address or FQDN of the server(s) the TIM should

synchronize with.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 51 52

Brak uwag

Arcom ZyWAN Instrukcja Obsługi Strona 28